mass loss

The curve of heat release rate and mass loss rate had the same shape which showed that irradiation cross-linking had the effect in the condense phase. The char formed after cone calorimetric test had the wrinkle structure to wrap the melt drops.

锥形量热仪测试的热释放速率和质量损失速率曲线轮廓类似，也说明了辐照交联在凝聚相起到的作用；燃烧后炭层呈褶皱状结构，有利于对熔滴的包覆。

互联网摘选

Quantitative analyzed the mass loss rate, ionic species, quality change of Smart Soil under chemical erosion actions, deduced the ionic equation of chemical response process.

定量分析受化学溶蚀的生态土的质量损失率，离子种类、质量变化，推断化学反应过程的离子方程式。

互联网摘选

High vacuum will speed up the cooling process while it makes the mass loss increase.

提高真空度可以加快预冷过程，但会增加物料的质量损失。

互联网摘选

The mass loss ratio of silicon rubber increased and thermal stability reduced after irradiation.

辐照后硅橡胶的质损率增加，耐热性能下降；

互联网摘选

The relative erosion resistance and erosion mechanism was studied through measuring the rate of mass loss and SEM observation.

通过测定试样冲蚀失重率及扫描显微镜显微分析方法，研究材料在含沙清水和含沙海水中的相对耐冲蚀性和冲蚀机制。

互联网摘选

High vacuum will speed up cooling process while it makes the mass loss increase.

提高真空度可以加快预冷过程,但会增加物料的质量损失.

网络文摘精选

The new-born surface resulted from the mass loss could not be neglected.

质量损失所产生的新生表面积不能忽略；

互联网摘选

At higher thermal radiation intensity, all samples produced the heat release rate and peaks have increased, the total heat release increased, mass loss increased, but the effective heat of combustion is about the same.

在较高的热辐射强度下，所有的试件产生的热释放速率及其峰值都有所增加，总放热量增大，质量损失增多，但有效燃烧热都相差不大。

互联网摘选

Igniting time and the mass loss rate were remarkably different for various parts of the bamboo pole.

结果表明，点燃时间、第二释热峰出现的时间及峰值、质量损失速率与竹材两表面的去与不去有极显著线性相关关系；

互联网摘选

Mass loss rates of fir leaf litter appeared consistent with the taxa and individual relative density of soil fauna.

不同孔径凋落物袋内土壤动物的类群和个体相对密度与凋落叶的质量损失率呈现相对一致的变化趋势。

互联网摘选

During 8 weeks of degradation in vitro, and the mass loss ratio was about 15.6%, the accumulative releas rate of hydroxyproline is 62.8%.

在8周的考察期内，支架质量损失了15.6%，羟脯氨酸的累计释放率为62.8%。

互联网摘选

The wear mass loss of the Mo2Ni3Si/ NiSi silicide composite coatings increases very slowly with increasing wear test load under room-temperature sliding wear test conditions.

在常温滑动磨损条件下，Mo2Ni3Si/NiSi金属硅化物复合材料涂层的质量损失随着载荷的增加缓慢增加；

互联网摘选

There was no significant difference in mass loss ratio between PGLA films of different size in each degradation time.

不同尺寸牙周片在各降解周期的质量损耗率均无显著性差异。

互联网摘选

Retorting degree influenced the start temperature of mass loss and pyrolysis process at low-temperature stage, but had little effect on pyrolysis at high-temperature stage.

干馏度对半焦热解初析温度和低温段热解过程有影响，但对高温段热解影响不明显，高温干馏所制取的半焦其热解过程包含于低温所制取的半焦热解过程中；

互联网摘选

Osteoporosis ( OP) is a bone metabolic disease in a characterized by bone mass loss and its tissue regressive changes.

骨质疏松（osteoporosis OP）是以骨质量的丢失以及骨组织的退变为特征的骨代谢疾病。

互联网摘选

The mass loss rates and sound point positions. for an adiabatic expanding process from Mira variables

Mira变星的绝热膨胀过程的质量损失率和声点半径

互联网摘选

Observational evidence for stellar winds obtained from radio, infrared, visible, UV and X-ray regions are given. And two important parameters, terminal velocity and mass loss rate, are discussed.

在观测方面，给出了从射电、红外，可见光、紫外和X射线各波段得到的观测证据，并介绍了星风的两个重要参数、星风的终速和质量损失率。

互联网摘选

Internal gas mass loss analysis of inflatable space antenna reflector subjected to impact

空间充气天线反射器受冲击气体质量损失分析

互联网摘选

In addition, mass loss rate was not the only parameter influencing heat release rate in cone calorimeter for agaric.

同时，木耳的质量损失速率不是影响其热释放速率的惟一因素。

互联网摘选

A further discusses concerning the mass loss rates from Mira variables

关于Mira变星质量损失率的进一步讨论

互联网摘选

At a certain atmosphere, the characteristic temperature and mass loss proportion during wood pyrolysis is not quiet different from species.

在一定气氛下，木材热解失重过程中的特征温度值和失重率，在不同树种之间的差异较小；

互联网摘选

The burning behavior of 3 mm-thick PVC slabs ( 100 mm × 100 mm) at different temperatures was studied with a cone calorimeter. A single equation model of mass loss rate vs time was simulated with a chemical kinetic method.

使用锥形量热仪研究了聚氯乙烯（PVC）薄板在不同温度下的燃烧反应，采用化学动力学法拟合了PVC燃烧过程中质量损失率与时间的单方程模型。

互联网摘选

The results show that after 45h of cavitation erosion test, the mass loss of the specimen with ground surface was 1.57 times of that with TIG remelted surface.

结果表明：在45h空泡腐蚀试验后，磨削试样的累积失重量是TIG表面重熔试样的1.57倍；

互联网摘选